3D · JP041A
Inspect the lid, hinge or sliding drawer in normal use.
A paper wing on the lid and mating 15 mm lower tuck connect the two shells behind a cut-cross inner tray.

Main source shell reference dimensions. Inside dimensions describe the completed inner tray cavity and closed roof.
Complete closed assembly envelope: 301.6 × 252 × 82.4 mm
Inspect the lid, hinge or sliding drawer in normal use.
Outside artwork prints on wrapping paper. Inside artwork prints on lining paper. Greyboard remains a separate core.
Preview colours are separate from material caliper and print-ready colour specifications.
| Blank | Material | Caliper | Per set | Order blanks | Net area / set |
|---|---|---|---|---|---|
| Greyboard core | 2 mm | 1 | 100 | 0.1181 m² | |
| Outer wrapping paper | 0.2 mm | 1 | 100 | 0.1321 m² | |
| Greyboard core | 2 mm | 1 | 100 | 0.1181 m² | |
| Outer wrapping paper | 0.2 mm | 1 | 100 | 0.1515 m² | |
| Greyboard core | 2 mm | 1 | 100 | 0.1467 m² | |
| Outer wrapping paper | 0.2 mm | 1 | 100 | 0.1777 m² |
Net areas exclude holes and overlaps between panels in the same blank. Stock sheets, waste and adhesive are separate.
Different calipers have independent sheet plans. Each component remains a distinct blank. Prepared greyboard uses the full rectangular stock for sheet yield.
Sheet sizes are format references; the model uses 2 mm material. Confirm stock, grain and availability in the quotation.
All materials selected for SVG, DXF and OBJ. Animated glTF and the editable record contain the complete assembly.
Six outlines. The source shows a nominal 79 mm continuing rear wing and a 15 mm mating lower tuck. The upper wing is a material connection over the lower shell. The lower part of the wing stays on the base as the upper shell rotates. The fixed inner tray uses a non-V board-hinge operation and has a small front-to-rear fit allowance for the opening sweep. Editable geometry was reconstructed from the archived drawing, dimension table and available reference views. Neutral-axis allowances, adhesive, paper joints and tooling require a prototype.
Packmage drawings, dimensions, options and accessible 3D states are recorded per design. EasyPackMaker provides independent construction-family and material-fit comparisons. Matching codes do not prove matching physical designs.
Tooling grooves, residual skin, adhesive compression, hardware and physical fit still require a supplier sample. This is an independently editable construction, with source-specific differences recorded; factory equivalence is not claimed.