3D · HC007
Inspect the lid, hinge or sliding drawer in normal use.
A V-grooved base surrounds a three-sided collar. The lid pivots along its fixed full-depth rear leaf.

Tray core groove axes. Finished inside depth is measured from the floor lining to the underside of the inset lid.
Complete closed assembly envelope: 282.4 × 342.4 × 71.4 mm
Inspect the lid, hinge or sliding drawer in normal use.
Outside artwork prints on wrapping paper. Inside artwork prints on lining paper. Greyboard remains a separate core.
Preview colours are separate from material caliper and print-ready colour specifications.
| Blank | Material | Caliper | Per set | Order blanks | Net area / set |
|---|---|---|---|---|---|
| Greyboard core | 2 mm | 1 | 100 | 0.1820 m² | |
| Outer wrapping paper | 0.2 mm | 1 | 100 | 0.2172 m² | |
| Lining paper | 0.2 mm | 1 | 100 | 0.1777 m² | |
| Greyboard core | 2 mm | 1 | 100 | 0.1109 m² | |
| Outer wrapping paper | 0.2 mm | 1 | 100 | 0.1424 m² | |
| Lining paper | 0.2 mm | 1 | 100 | 0.1069 m² | |
| Greyboard core | 2 mm | 1 | 100 | 0.0612 m² | |
| Outer wrapping paper | 0.2 mm | 1 | 100 | 0.0826 m² |
Net areas exclude holes and overlaps between panels in the same blank. Stock sheets, waste and adhesive are separate.
Different calipers have independent sheet plans. Each component remains a distinct blank. Prepared greyboard uses the full rectangular stock for sheet yield.
Sheet sizes are format references; the model uses 2 mm material. Confirm stock, grain and availability in the quotation.
All materials selected for SVG, DXF and OBJ. Animated glTF and the editable record contain the complete assembly.
The dieline shows the folding blanks after corner waste removal. Use Raw stock groove DXF for the rectangular board and extended groove axes.
Eight blank outlines with both linings enabled. The source shows rectangular V-groove preparation for the base, a separate two-face board lid, three-sided collar and paper on both structures. The three collar walls leave room for the separate rear leaf of the lid. The thumbnail and two-face cut pattern support the opening arrangement. Editable geometry was reconstructed from the archived drawing, dimension table and available reference views. Neutral-axis allowances, adhesive, paper joints and tooling require a prototype.
Packmage drawings, dimensions, options and accessible 3D states are recorded per design. EasyPackMaker provides independent construction-family and material-fit comparisons. Matching codes do not prove matching physical designs.
Tooling grooves, residual skin, adhesive compression, hardware and physical fit still require a supplier sample. This is an independently editable construction, with source-specific differences recorded; factory equivalence is not claimed.