3D · DM002
Inspect the lid, hinge or sliding drawer in normal use.
An integral-back sleeve receives a wrapped rigid drawer with an aligned pull slit.

Drawer core crease axes and usable drawer interior. Outside dimensions cover the closed sleeve and projecting pull.
Complete closed assembly envelope: 282.1 × 128.6 × 63.9 mm
Inspect the lid, hinge or sliding drawer in normal use.
Outside artwork prints on wrapping paper. Inside artwork prints on lining paper. Greyboard remains a separate core.
Preview colours are separate from material caliper and print-ready colour specifications.
| Blank | Material | Caliper | Per set | Order blanks | Net area / set |
|---|---|---|---|---|---|
| Greyboard core | 2 mm | 1 | 100 | 0.1098 m² | |
| Outer wrapping paper | 0.2 mm | 1 | 100 | 0.1212 m² | |
| Greyboard core | 2 mm | 1 | 100 | 0.0753 m² | |
| Outer wrapping paper | 0.2 mm | 1 | 100 | 0.0982 m² | |
| Lining paper | 0.2 mm | 1 | 100 | 0.0060 m² | |
| Ribbon stock | 0.2 mm | 1 | 100 | 10 mm × 16 mm |
Net areas exclude holes and overlaps between panels in the same blank. Stock sheets, waste and adhesive are separate.
Different calipers have independent sheet plans. Each component remains a distinct blank. Prepared greyboard uses the full rectangular stock for sheet yield.
Sheet sizes are format references; the model uses 2 mm material. Confirm stock, grain and availability in the quotation.
The stock width matches the actual ribbon blank. Cut length follows its local length direction, including for a ribbon wider than it is long.
| Ribbon | Width | Cut per piece | Pieces | Metres |
|---|---|---|---|---|
| Pull ribbon stock (interpreted) | 16 mm | 10 mm | 100 | 1.000 m |
Each ribbon type is planned separately. Spool quantities account for whole cuts per spool. Ribbon attachment and any shaped ends remain supplier assembly operations.
All materials selected for SVG, DXF and OBJ. Animated glTF and the editable record contain the complete assembly.
Six observed outlines. The isolated small rectangle and nearby slit appear in the cut plan and the thumbnail shows the pull. Its 10 × 16 mm ribbon assignment is supported by matching parameters and geometry in the related JP006V reference. Ribbon gauge and insertion are nominal. The 116 × 52 mm rectangle is reproduced as a separate paper lining at the inside rear. The source does not identify its stock or placement. The archived source 3D returned No Permission. Editable geometry was reconstructed from the archived drawing, dimension table and available reference views. Neutral-axis allowances, adhesive, paper joints and tooling require a prototype.
Packmage drawings, dimensions, options and accessible 3D states are recorded per design. EasyPackMaker provides independent construction-family and material-fit comparisons. Matching codes do not prove matching physical designs.
Tooling grooves, residual skin, adhesive compression, hardware and physical fit still require a supplier sample. This is an independently editable construction, with source-specific differences recorded; factory equivalence is not claimed.