3D · JP006V
Inspect the lid, hinge or sliding drawer in normal use.
A separately wrapped rigid tray has a 16 mm ribbon opening and its own sleeve allowances.

Complete closed assembly envelope: 282.2 × 127.8 × 61.8 mm
Inspect the lid, hinge or sliding drawer in normal use.
Outside artwork prints on wrapping paper. Inside artwork prints on lining paper. Greyboard remains a separate core.
Preview colours are separate from material caliper and print-ready colour specifications.
| Blank | Material | Caliper | Per set | Order blanks | Net area / set |
|---|---|---|---|---|---|
| Greyboard core | 2 mm | 1 | 100 | 0.1091 m² | |
| Outer wrapping paper | 0.2 mm | 1 | 100 | 0.1199 m² | |
| Greyboard core | 2 mm | 1 | 100 | 0.0753 m² | |
| Outer wrapping paper | 0.2 mm | 1 | 100 | 0.0982 m² | |
| Ribbon stock | 0.2 mm | 1 | 100 | 10 mm × 16 mm | |
| Lining paper | 0.2 mm | 1 | 100 | 0.0060 m² |
Net areas exclude holes and overlaps between panels in the same blank. Stock sheets, waste and adhesive are separate.
Different calipers have independent sheet plans. Each component remains a distinct blank. Prepared greyboard uses the full rectangular stock for sheet yield.
Sheet sizes are format references; the model uses 2 mm material. Confirm stock, grain and availability in the quotation.
The stock width matches the actual ribbon blank. Cut length follows its local length direction, including for a ribbon wider than it is long.
| Ribbon | Width | Cut per piece | Pieces | Metres |
|---|---|---|---|---|
| Flexible ribbon pull stock | 16 mm | 10 mm | 100 | 1.000 m |
Each ribbon type is planned separately. Spool quantities account for whole cuts per spool. Ribbon attachment and any shaped ends remain supplier assembly operations.
All materials selected for SVG, DXF and OBJ. Animated glTF and the editable record contain the complete assembly.
A wrapped cut-cross greyboard drawer slides inside a five-sided sleeve. The separate ribbon blank and rear-wall lining rectangle remain separate material components. Each source retains its own slit, ribbon-stock size, and sleeve allowances. The rear rectangle is interpreted as rear-wall lining from the drawing and paper settings. C/V ribbon gauge is explicitly nominal; A exposes 0.2 mm. This is an independently reconstructed editable material model. V-groove width/depth, half-cut residual skin, adhesive film, ribbon retention and sliding friction are nominal; source or factory equivalence is not asserted.
Packmage drawings, dimensions, options and accessible 3D states are recorded per design. EasyPackMaker provides independent construction-family and material-fit comparisons. Matching codes do not prove matching physical designs.
Tooling grooves, residual skin, adhesive compression, hardware and physical fit still require a supplier sample. This is an independently editable construction, with source-specific differences recorded; factory equivalence is not claimed.