3D · HC105A
Inspect the lid, hinge or sliding drawer in normal use.
A separate receiving cap closes a four-panel sleeve around a half-cut cross tray.

Complete closed assembly envelope: 200.2 × 149.1 × 50.1 mm
Inspect the lid, hinge or sliding drawer in normal use.
Outside artwork prints on wrapping paper. Inside artwork prints on lining paper. Greyboard remains a separate core.
Preview colours are separate from material caliper and print-ready colour specifications.
| Blank | Material | Caliper | Per set | Order blanks | Net area / set |
|---|---|---|---|---|---|
| Greyboard core | 2 mm | 1 | 100 | 0.0776 m² | |
| Greyboard core | 2 mm | 1 | 100 | 0.0068 m² | |
| Outer wrapping paper | 0.2 mm | 1 | 100 | 0.0960 m² | |
| Greyboard core | 2 mm | 1 | 100 | 0.0552 m² | |
| Outer wrapping paper | 0.2 mm | 1 | 100 | 0.0741 m² | |
| Lining paper | 0.2 mm | 1 | 100 | 0.0531 m² |
Net areas exclude holes and overlaps between panels in the same blank. Stock sheets, waste and adhesive are separate.
Different calipers have independent sheet plans. Each component remains a distinct blank. Prepared greyboard uses the full rectangular stock for sheet yield.
Sheet sizes are format references; the model uses 2 mm material. Confirm stock, grain and availability in the quotation.
All materials selected for SVG, DXF and OBJ. Animated glTF and the editable record contain the complete assembly.
A separate keyed receiving cap closes the sleeve rear. Its tabs meet real open-edge sleeve rebates; it is not an integral fifth sleeve panel. The greyboard drawer uses a cut-cross/half-cut core, separate cross wrap and optional cross liner. Rectangular corner-groove stock is not substituted. This is an independently reconstructed editable material model. V-groove width/depth, half-cut residual skin, adhesive film, ribbon retention and sliding friction are nominal; source or factory equivalence is not asserted.
Packmage drawings, dimensions, options and accessible 3D states are recorded per design. EasyPackMaker provides independent construction-family and material-fit comparisons. Matching codes do not prove matching physical designs.
Tooling grooves, residual skin, adhesive compression, hardware and physical fit still require a supplier sample. This is an independently editable construction, with source-specific differences recorded; factory equivalence is not claimed.