3D · JP037
Inspect the lid, hinge or sliding drawer in normal use.
Two shallow front bands close around one independent wrapped tray.

Complete closed assembly envelope: 350.4 × 202.4 × 82.4 mm
Inspect the lid, hinge or sliding drawer in normal use.
Outside artwork prints on wrapping paper. Inside artwork prints on lining paper. Greyboard remains a separate core.
Preview colours are separate from material caliper and print-ready colour specifications.
| Blank | Material | Caliper | Per set | Order blanks | Net area / set |
|---|---|---|---|---|---|
| Greyboard core | 2 mm | 1 | 100 | 0.1922 m² | |
| Outer wrapping paper | 0.2 mm | 1 | 100 | 0.2343 m² | |
| Lining paper | 0.2 mm | 1 | 100 | 0.0819 m² | |
| Greyboard core | 2 mm | 1 | 100 | 0.1431 m² | |
| Outer wrapping paper | 0.2 mm | 1 | 100 | 0.1746 m² |
Net areas exclude holes and overlaps between panels in the same blank. Stock sheets, waste and adhesive are separate.
Different calipers have independent sheet plans. Each component remains a distinct blank. Prepared greyboard uses the full rectangular stock for sheet yield.
Sheet sizes are format references; the model uses 2 mm material. Confirm stock, grain and availability in the quotation.
All materials selected for SVG, DXF and OBJ. Animated glTF and the editable record contain the complete assembly.
Five pieces. Two short 34.8 mm case bands form the front returns. Their tray is a half-cut cross with a different width and wall height from JP037V. Its 6 mm radius pockets align with 5 mm radius upper case pockets. Positions are derived from the source drawings and displayed dimensions. Nominal full-caliper fit allowances are recorded separately from the captured vendor sizes. The editable core pockets represent covered closure cavities. Hidden hardware, groove tooling and paper hinge flex require physical validation.
Packmage drawings, dimensions, options and accessible 3D states are recorded per design. EasyPackMaker provides independent construction-family and material-fit comparisons. Matching codes do not prove matching physical designs.
Tooling grooves, residual skin, adhesive compression, hardware and physical fit still require a supplier sample. This is an independently editable construction, with source-specific differences recorded; factory equivalence is not claimed.